How HEAT uses your travel data

You can enter walking and cycling data in different ways, depending on the source. For example, you may have data on time, distance, trips, steps, frequency or mode share.

HEAT converts these inputs into common units so that they can be used in the calculations, mainly minutes or kilometres per person per day. Where needed, HEAT uses default values for conversions, such as average speed or trip distance. You can change these values where you have better local data.

How does HEAT convert different types of data?

  • Time and distance: HEAT uses an average speed for each travel mode to convert between duration and distance.
  • Steps: HEAT uses an average step length to estimate distance.
  • Trips or counts: HEAT uses an average trip distance for the relevant travel mode to estimate distance.
  • Mode share: HEAT combines the percentage of trips made by walking or cycling with the average total travel per person per day in the study area. It then converts the result into the required unit.
  • Frequency: You can report how often people walk or cycle using five categories:
    • daily or almost daily;
    • 1–3 days per week;
    • 1–3 days per month;
    • less than once per month; or
    • never.

For frequency data, HEAT estimates the number of days per year using the midpoint of each category. It then combines this with an estimated daily distance to calculate the average amount of walking or cycling per day.

Percent change

For two-case assessments, you can enter the comparison case as a percentage change from the reference case. For example, a 20% increase means that the amount of walking or cycling in the comparison case is 20% higher than in the reference case.