Start using HEAT

Please consider the explanations below before you start using the HEAT tool.

HEAT works at a population level.

The tool estimates impacts for groups of people, but cannot predict health of individuals.

HEAT is designed for habitual behaviour.

HEAT is meant for assessments of regular behaviours, such as cycling or walking for commuting, running errands or related to child care, as well as regular leisure time activities. In the HEAT assessment, an annual average is derived. Thus, users should not use the HEAT for the evaluation of one-off events or competitions (such as single walking or cycling days etc.), since these are unlikely to reflect repeated, ideally habitual behaviour.

HEAT is designed for adult populations.

HEAT calculations are based on mortality rates for the age ranges of 20–74 years for walking and 20–64 years for cycling. HEAT should not be applied to populations of children or adolescents, since the scientific evidence used by HEAT does not include these age groups. The upper age boundaries have been set by consensus to avoid inflating health benefits from misrepresenting active travel behaviour among older age groups that have higher mortality risks. If the assessed population is considerably younger or older than average, the user can specify a lower or higher age range.

HEAT can be used for different cycling categories

HEAT allows for the distinction of conventional cycling, e-biking (i.e. cycling with electric assist), and bike share. Unless otherwise stated, documentation referring to cycling applies to all three types of cycling. However, bike share cannot be combined with other modes, including other cycling modes.

The tool is not suited for populations with very high average levels of walking or cycling.

HEAT applies evidence from studies in the general population and not in subpopulations with very high average levels of physical activity, such as bicycle couriers or mail personnel. Although the exact shape of the dose–response curve is uncertain, benefits from physical activity seem to start to slow above levels equivalent to perhaps 1.5 hours of cycling and 2 hours of brisk walking per day. The tool is therefore not suited for populations with average levels of cycling of about 1.5 hours per day or more or of walking of about 2 hours per day or more, which exceed the activity levels common in an average adult population.

The air pollution module is not suited for environments with very high levels of air pollution.

Most of the studies on health effects of cycling and walking and of air pollution used for HEAT have been carried out in environments with low or medium levels of air pollution (i.e. concentrations of fine particulate matter up to about 50ug/m3, see more information here. While it seems that negative effects from air pollution start to level off at higher levels, effects on cyclists and pedestrians have not yet been well studied at such levels of exposure. Thus, caution has to be used in interpreting results at higher levels of air pollution, and impacts are capped as of 100ug/m3 to avoid inflated results (see here).

HEAT results involve uncertainty.

Knowledge of the health effects of walking and cycling is constantly evolving. The HEAT project is an ongoing consensus-based effort of translating basic research into a harmonized methodology. Despite relying on the best available scientific evidence, on several occasions the tool methodology required the advisory groups (see acknowledgements) to make expert judgements. The most important assumptions underlying the HEAT impact assessment approach are described here. Therefore, the accuracy of results of the HEAT calculations should be understood as estimates of the order of magnitude, much like many other economic assessments of health effects. HEAT is regularly being updated as new knowledge becomes available.

A HEAT assessment is composed of the following main steps:

  • defining the assessment
  • providing travel data
  • optionally adjust travel data
  • optionally provide additional data
  • review of calculation parameters
  • results

Depending on the characteristics of an assessment, a varying number of questions will apply.

How to navigate the tool

At the start, choose one of the three interface options to show more or fewer questions.

The menu on the left shows where you are in the assessment and lets you return to previous sections.

Use “Next” and “Back” to move between pages. You can also select any previous section in the menu to review or change your entries. After making a change, use “Next” to continue. Only sections affected by the change will need to be completed again; your other entries will be retained.

Click the “?” icon next to an entry for additional information and tips.

Further guidance is available in the HEAT FAQ section.

For questions or comments on HEAT please email to heatwalkingcycling@who.int.